Table of Contents
Advertisement
ASSEMBLY
1. Fasten the Snowmobile attachment to the T-1250 lift
saddle with the provided bolts.
2. Once secure install angle bracket and threaded rod/
hook assembly.
3. Review adapter and lift assembly to confirm proper
fitment.
OPERATION
1. Line up vehicle undercarriage with saddle.
2. Lift saddle to just before contact to ensure the contact
area will be in a proper location.
!
WARNING: Use only on hard, level surfaces ca-
pable of sustaining rated capacity loads.
3. Pull lift back until saddle stop plate makes contact with
snowmobile tunnel.
4. Close Hydraulic Release Valve and carefully pump
jack until vehicle reaches desired height. Final height
must correspond with the locking teeth on the Height
Locking Lever.
5. Carefully turn the Release Knob counterclockwise
until the Lift Platform engages the Height Locking
Lever, then close the Release Knob by turning it fully
clockwise. Do not work around or under load un-
less Height Locking Lever is properly engaged.
!
CAUTION: Clear all tools and personnel before
lowering load. Only attachments and/or adapters
supplied by the manufacturer shall be used with
this device.
6. To lower the Lift Platform pump the Lift Pedal several
times to disengage the Height Locking Lever, then
depress the Height Unlocking Lever pedal. Carefully
turn the Release Knob counterclockwise to lower the
load slowly.
MAINTENANCE
Keep lift clean and well lubricated. Apply a couple of
drops of light machine oil to all pivoting joints as needed.
Thoroughly wipe up excess oil.
Lubrication
A periodic coating of light lubricating oil to pivot points,
axles and hinges will help to prevent rust and assure
that wheels, casters and pump assemblies move freely.
Cleaning
Check the pump piston and Ram occasionally for signs
of rust or corrosion. Clean as needed and wipe with an
oily cloth.
Storage
When lift is not in use, Lift Platform should be stored in
the fully retracted position.
Figure 3 - Snowmobile Attachment Assembly
4
Advertisement
Table of Contents
