Advertisement
Customer Care Europa & Africa
© 2002 SCCE Training Group
Additional information
Tuning support
For tuning the 5510 it is a good solution to use the AAS-6 RF adapter from NHM5/6 3310/3330. (See picture below)
Disassemble the B-cover and the antenna assembly. Now connect the AAS-6 RF adapter. (See picture below)
AAS-6
RF-adapter
Modify the MJS-64 Test Jig
Sometimes the BtoB connector is not connected correctly to the phone PWB MA4, i.e. the connection block with integrated BtoB
connector has no or unsteady contact. The pressure between BtoB connector and phone PWB has to be increased. (See following
pictures below)
Remove the PWB with integrated BtoB connector and assemble e.g. springs between PWB and connector block to get closer to
the phone PWB MA4. The distance between connector block and PWB with integrated BtoB connector must be about 1-2mm.
When using e.g. springs there is the possibility to adjust the distance with a screwdriver. (See picture below)
B to B connector
npm_5_repair_v1_0.doc
Fixing screws for connection between
MJS-64 and MJS-19 Jig
6x screws
CONFIDENTIAL
Product NPM-5
Introduction
Date 08.04.2002
BBS-8
Service Battery
Connector
block
PWB with integrated
B to B connector
Checked by:
SCCE Training Group
5(11)
Repairhints
Version 1.0 Approved
The screws on this
side are not
reachable
when both jigs
are connected
1-2 mm
Approved by:
SCCE
Advertisement
