Marquis Crown Summit Owner's Manual page 43

MAINTENANCE
NOTE: Due to the high-gloss, fine finish of the acrylics, imperfections in the surface texture may
occur. A natural aging process in acrylic can lead to a process called crazing. Fine spider web-
like lines can form on the cosmetic surface of acrylic over time after exposure to the elements
and chemicals.
Crazing represents no structural weakening of acrylic and is not covered under the warranty.
Fading, staining and discoloration may also occur but represent no structural degradation and are
not covered under warranty.
NOTE: Do not leave an empty spa uncovered. Direct sunlight on the spa surface can cause severe
damage or blemishing, cause fittings to discolor and can result in the voiding of any surface
warranties.
Refill the Spa
Fill the spa with fresh water from a garden hose and balance the water as described in the Water
Treatment section. The use of a Fill Filter is recommended when filling especially in areas of high
mineral content in the water. Attach to the end of a garden hose to filter out any grit and sediment
that could accumulate in the spa and potentially scratch the spa surface.
AS NEEDED MAINTENANCE
Weather Shield Cover Care
™
Weather Shield is a solution dyed polyester fabric designed to be flexible and easy for
manufacturers to use. Its urethane coating enhances the stability of the weave and allows for
greater water resistance, while also minimizing shrinkage and stretching. Weather Shield features a
high UV, water and mold and mildew resistance and has excellent tear and abrasion resistance.
Care & Cleaning
Weather Shield is designed to be easy to maintain. It can be washed, or brushed off and rinsed.
Proper care and cleaning is important to the life of all fabrics.
For Normal Care and Cleaning
• Add 2 ounces of mild soap such as Woolite or Dawn dishwashing liquid to 1 gallon of
lukewarm water.
• Clean the fabric with a "soft bristle brush."
• Rinse thoroughly with cold water and air dry.
For Stubborn Stains
• Add maximum 1 cup of bleach to one 1 gallon of water.
• Spray on lightly to the fabric face (non-coated side). Do not soak fabric.
• Prolonged exposure to harsh chemicals can damage the coating.
• Rinse immediately. Do not leave on for more than 2 minutes.
• Cleaning with harsh cleaners such as bleach will require a retreatment like
• 303 High Tech Fabric Guard for restoring water repellency.
43