Operation - Makita DVC265 Instruction Manual

OPERATION

WARNING:
Operators shall be adequately
instructed on the use of the vacuum cleaner.
WARNING:
This vacuum cleaner is not suit-
able for picking up hazardous dust.
CAUTION:
This cleaner is for dry use only.
CAUTION:
This cleaner is for indoor use only.
CAUTION:
Always insert the battery cartridge
all the way until it locks in place. I f y ou c an see t h e
re d in d i c ator on t h e upper si d e o f t h e button, it is not
lo c ke d c ompletel y . I nsert it f ull y until t h e re d in d i c ator
c annot be seen. I f not, it ma y a c c i d entall y f all out o f
the tool, causing injury to you or someone around
y ou.
CAUTION:
During operation, be conscious
of the vacuum cleaner on your back. Y ou ma y
lose y our balan c e i f t h e v a c uum c leaner bo d y bumps
against a w all or t h e h ose is h ooke d b y an obsta c les.
1. S h oul d er t h e v a c uum c leaner bo d y an d f as-
ten lower and upper belts. Adjust the tightness as
ne c essar y .
Fig.26
2. P ress button to start v a c uuming. T o c h ange
t h e su c tion po w er, press
c leaner is running. T h e su c tion po w er s w it c h es bet w een
normal ( 1 ) an d h ig h er ( 2 ) su c tion po w er. P ress
ton to stop.
Fig.27
D uring t h e operation, h ook t h e s w it c h bo x on t h e lo w er
belt or t h e D -ring.
Fig.2 8
Replace the filter bag when it becomes full. Open
3.
the lid and take out the filter bag. Pull the strip on the
side of the opening to shut the filter bag and dispose of
the filter bag in whole.
Fig.29: 1. S trip
W h en using a d ust bag, take out t h e d ust bag an d d is-
pose o f t h e d ust b y releasing t h e lat c h .
Fig.30: 1. L at c h
Periodically check the filter bag if it is
NOTICE:
full. Continuous use with the filter bag full results in
re d u c e d su c tion po w er.
Do not use an used filter bag. The filter
NOTICE:
bag is designed for single use. Using filter bag repeat-
edly may cause clogging of the filter and results in
d amage to t h e c leaner. I f y ou w ant to use t h e bag
repeate d l y , use a d ust bag.
button w h ile t h e v a c uum
but-
W IRELESS ACTIVATION
FUNCTION
W hat you can do with the wireless
activation function
T h e w ireless a c ti v ation f un c tion enables c lean an d
c om f ortable operation. B y c onne c ting a supporte d tool
to t h e c leaner, y ou c an run t h e c leaner automati c all y
along w it h t h e s w it c h operation o f t h e tool.
Fig.31
NOTICE:
Be sure to refer to the instruction man-
ual of the tool when using the cleaner with wire-
less activation function.
NOTICE:
Do not disassemble or tamper with the
wireless unit.
NOTICE:
To prevent dust coming into the slot
of the wireless unit, always close the lid securely
during operation and storage.
NOTICE:
Do not remove the wireless unit while
the power is being supplied. D oing so ma y c ause a
mal f un c tion o f t h e w ireless unit.
NOTICE:
Do not press the wireless activation
button too hard and/or press the button with an
object with a sharp edge.
NOTE: W ireless a c ti v ation nee d s Makita tools
e q uippe d w it h t h e w ireless unit.
NOTE: P rior to t h e initial use o f t h e w ireless a c ti v a-
tion f un c tion w it h ea c h tool, t h e tool registration is
required. Once the registration is finished with the
tool, t h e re-registration is not re q uire d unless it is
c an c elle d .
NOTE: Be f ore registration, be sure t h at t h e w ireless
unit is properl y inserte d .
NOTE: O ne w ireless unit c an register up to 1 0 links
w it h ot h er w ireless units. I f more t h an 1 0 ot h er w ire-
less units are registere d to one w ireless unit, t h e one
registere d earliest w ill be c an c elle d automati c all y .
NOTE: T h e position o f t h e w ireless a c ti v ation button
v aries d epen d ing on t h e tool.
NOTE: T h e c leaner also starts b y pressing
w h en t h e stan d -b y s w it c h is set to " I ( O N ) " .
H o w e v er t h e button w ill not w ork w h en t h e w ire-
less a c ti v ation f un c tion is use d .
15 ENGLISH
button