Husqvarna Automower 405X Operator's Manual page 23

2
Area, m Recommended operating
time, h
500 10
1000 17
1500 24
3.10.3.3 To copy the schedule setting
To get access to the menu on
1. Do steps 1–3 in
page 22 .
2. Use the arrow buttons and the OK button to move
through the menu structure
Copy .
3. Use the arrow buttons and the OK button to copy
the schedule setting. You can copy the schedule
settings day to day or for the full week.
3.10.3.4 To reset the schedule setting
You can remove all schedule settings and use the
factory setting.
To get access to the menu on
1. Do steps 1–3 in
page 22 .
2. Use the arrow buttons and the OK button to move
through the menu structure
Reset .
a) Push the arrow buttons to select
to only reset the current day to factory
settings.
b) Push the arrow buttons to select
reset all schedule settings to factory settings.
3. Push the OK button.
3.10.4 Cutting height
3.10.4.1 Adjust the cutting height
CAUTION:
During the first weeks after
a new installation, the cutting height must be
set to MAX to avoid damaging the loop wire.
After this, the cutting height can be lowered
step by step every week until the desired
cutting height has been reached.
1650 - 003 - 24.02.2021
The cutting height can be varied from MIN (2 cm / 0.8
in.) to MAX (5 cm / 2 in.).
To set the cutting height
1.
2.
3.
4.
3.10.4.2 TargetHeight
Schedule > Overview >
Use the TargetHeight function to lower the cutting height
from MAX to the specified cutting height gradually during
10 days. If you change the cutting height manually
during this time it will disable the TargetHeight function.
To set the TargetHeight
1.
2.
3.
4.
3.10.5 Security level
Schedule > Overview >
There are 3 security levels for the product.
Current day
All week to
•
•
•
3.10.5.1 To set the security level
Select 1 of 3 security levels for your product.
1.
Do steps 1–3 in To get access to the menu on
page 22 .
Use the arrow buttons and the OK button to move
through the menu structure
Cutting height .
Use the arrow buttons to set the cutting height.
Push the OK button.
Do steps 1–3 in To get access to the menu on
page 22 .
Use the arrow buttons and the OK button to move
through the menu structure
TargetHeight .
Push the OK button to enable or disable the
function.
Push the BACK button.
Function Low
PIN code
STOP button
pressed
Carried away
PIN-code - The correct PIN-code must be entered
to get access to the menu structure of the product.
If the incorrect PIN-code is entered 5 times, the
product is locked for a time. The lock is extended
for each new incorrect try.
STOP button pressed - The alarm goes off if the
STOP button has been pushed and the PIN code
is not entered in less than 30 seconds.
Carried away - The alarm goes off if the product is
lifted.
Do steps 1–3 in To get access to the menu on
page 22 .
Cutting height >
Cutting height >
Medium High
X X
X
X
Installation - 23