Advertisement
2) Economy Mode heats the spa to the set temperature only during filter cycles. "
when temperature is not current, and will alternate with temperature when temperature is current.
3) Sleep Mode heats the spa to within 20°F/10°C of the set temperature only during filter cycles. "
will display solid when temperature is not current, and will alternate with temperature when temperature is
current.
(8) Preset Filter Cycles
The first filter cycle begins 6 minutes after the spa is energized. The second filter cycle begins 12 hours later.
Filter duration is programmable for 2, 4, 6, 8 hours or for continuous filtration (indicated by "
default filter time is 2 hours. To program, press "Temp" or "Set," then "Jets." Press "Temp" or "Set" to
adjust. Press "Jets" to exit programming. The blower purges for 30 seconds at the beginning of each filter
cycle. The low speed of the pump runs during filtration and the ozone generator (if installed) will be
enabled.
(9) Freeze Protection
If the temperature sensors detect a drop to below 44°F/6.7°C within the heater, the pump and blower will
automatically activate to provide freeze protection. The equipment stays on until 4 minutes after the sensors
detect that the spa temperature has risen to 45°F/7.2°C or higher. In colder condition, an optional additional
freeze sensor may be added to protect against freeze conditions that may not be sensed by the standard
sensors. Aux freeze sensor protection acts similarly except with the temperature thresholds determined by
the switch and without a 4-minute delay in turnoff. See your dealer for details.
3. Diagnostic Messages
Message
No message on display.
Temperature unknown.
"Overheat" The spa is shut down. One of
the sensors has detected118°F/48°C
at the heater.
"Overheat" The spa has shut down. One
of the sensors has detected that the spa
water is 110°F/43°C.
"Ice" Potential freeze condition detected. No action required. The pump and blower will
Spa is shut down. The sensor that is
plugged into the Sensor "A" jack is not
working.
Spa is shut down. The sensor that is
plugged into the Sensor "B" jack is not
working.
Sensors are out of balance. If alternating
with spa temperature, it may just be a
temporary condition. If flashing by itself,
spa is shut down.
Meaning
Action Required
The control panel will be disabled until power
returns. Spa settings will be preserved until next
power up.
After the pump has been running for 2 minutes,
the temperature will be displayed.
DO NOT ENTER THE WATER. Remove the
spa cover and allow water to cool. Once the
heater has cooled, reset by pushing any button.
If spa does not reset, shut off the power to the
spa and call your dealer or service organization.
DO NOT ENTER THE WATER. Remove the
spa cover and allow water to cool. At
107°F/42°C, the spa should automatically reset.
If spa does not reset, shut off the power to the
spa and call your dealer or service organization.
automatically activate regardless of spa status
If the problem persists, contact your dealer or
service organization. (May appear temporarily
in an overheat situation and disappear when the
heater cools.)
If the problem persists, contact your dealer or
service organization. (May appear temporarily
in an overheat situation and disappear when the
heater cools.)
If the problem persists, contact your dealer or
service organization.
- 29 -
" will display solid
"
" The
Hide quick links:
Advertisement
