Important Safeguards - Brabantia BBEK1092 Instruction Manual

EN

IMPORTANT SAFEGUARDS

1. Please read the information and safety advice contained in these operating
instructions carefully and thoroughly before you use the Stand Mixer for the
first time.
2. The Stand Mixer should only be used for its intended purpose.
3. Before use, place the Stand Mixer on a horizontal and flat surface.
4. Place this appliance as close as possible to the power source so that you
can disconnect the plug quickly and easily.
5. This appliance should not be set up in close proximity to a naked flame,
inflammable materials (curtains, textiles, etc.), a radiator, an oven or any
other heat source.
6. To avoid an electric shock do not use this appliance in the vicinity of water.
Do not immerse the mains lead in water or other liquid.
7. Do not kink or clamp the mains lead. To avoid an accident do not allow the
mains lead to hang over the edge of a table or a counter.
8. Switch off the appliance before changing accessories or approaching parts
which move in use.
9. Make sure that the voltage shown on the rating plate corresponds to the
voltage of the mains supply. The rating plate can be found on the bottom of
the motor block. The Stand Mixer may only be connected to an AC power
supply (220~240V). The motor must always be switched off before the
Stand Mixer is connected to the mains supply. Turn the power switch (5) to
the off position.
10. The Stand Mixer must be operated with the type of power specified on the
rating plate. If you are unsure about the details of the available power
supply, ask your dealer or the local power supply company.
11. Unplug the appliance when not in use or before cleaning.
12. Do not use outdoors. This appliance is suitable for indoor use only.
13. Do not use the Stand Mixer when the head unit is lifted up.
14. During use, do not touch moving parts with your fingers.
15. Never operate the Stand Mixer when it is empty. Never leave the appliance
unsupervised when switched on.
16. Repairs should only be carried out by an authorised service centre.
17. Do not attempt to repair the Stand Mixer yourself, as opening or removing
covers will expose you to live components and other hazardous conditions.
18. If the supply cord is damaged, it must be replaced by the manufacturer, an
authorised service centre or a similarly qualified person in order to avoid a
1