QQ
3 7 63 1515 0
7.2.2 DISASSEMBLY
- Removing the Case and Holder(Fig.19)
1. Remove the six screws.
2. Remove the upper case, lower case and holder.
- Removing the Grille Assy(Fig.19)
1. Press the four tabs indicated by arrows and then pull
out the grille assy.
TE
L 13942296513
www
.
http://www.xiaoyu163.com
CDX-M8086ZT ,M8086ZT-91,M8186ZT ,M8186ZT-91
x
ao
u163
y
i
http://www.xiaoyu163.com
2 9
8
- Removing the Extension Unit(Fig.20)
1. Remove the one screw.
2. Unbend the two tabs indicated by arrows until
straight.
3. Remove the extension unit.
- Removing the Main Unit(Fig.20)
1. Remove the two screws and earth.
2. Unbend the tab indicated by arrow until straight.
3. Remove the main unit.
NOTE:
Connect the extension PCB to the main unit via the con-
nector, with the printing on the connector facing down-
ward.
A
Q Q
3
6 7
1 3
1 5
NOTE:
Fig. 19
To prevent screw A from working loose, apply glue
between screw A and the main unit when installing the
main unit to the CD mechanism unit.
Before disconnecting the connector, attach a short pin
as illustrated.
co
.
9 4
2 8
0 5
8
2 9
9 4
2 8
m
9 9
9 9
Fig. 20
49