Telos 2101 Series User Manual page 50

•
Confirm that the Desktop Director you will be using has power and says
"Talent" at the top of the screen. If it says "Producer" follow the directions
in Part V section 2.1.2 to change this Director to "Talent" mode.
•
Next, pick up the handset and press the left Line 1 button to select that line
for dialing. You should now hear dial tone on the handset.
•
Enter the phone number for a telephone line that has audio present, using the
dial pad (calling either the time or weather service works well for this).
•
Press the left Line 1 button and hang up the handset to place the call on
hybrid 1.
•
Bring up hybrid 1 on the console. You should hear the audio from the phone
line.
•
Look at the left meter on the 2101 Studio Interface and verify that this audio
is not present on the "1" LED bargraph. If this audio is present here you are
not feeding hybrid 1 a mix-minus and you must fix this problem before you
proceed.
IMPORTANT!
If you are using one of the routing schemes that requires only a single mix- minus you
should not have seen audio on either the "1" or "2" bargraphs in the previous test. In
that case you can skip the next test.
w
See section 3.3.1 for detailed information about the routing options.
Now we will verify the second mix-minus.
•
Press right Line 2 button to move the call made above to hybrid 2.
•
Bring up hybrid 2 on the console. You will hear the audio from the phone
line.
•
Look at the left meter on the 2101 Studio Interface and verify that this audio
is not present on the "2" LED bargraph. If this audio is present here you are
not feeding hybrid 2 a mix-minus and you must fix this problem before you
proceed.
•
Drop the call by pushing the Drop button
IV-50
TELOS 2101 USER'S MANUAL
PART IV
THE STUDIO INTERFACE & ADDITIONAL HYBRIDS
SECTION 2 – STUDIO INTERFACE CONFIGURATION
.