Siemens Stratos Outstation Installation Manual page 23

Maintenance
A InHand Router (End of Life)
A.1 Installation
1 Before installing the router in the rack, the SIM card needs to be installed. Remove the
panel at the top of the router and slide the SIM card into the slot.
2 The Router should be installed on a suitable rack-mounted shelf and held in position us-
ing the clamp provided (not shown). (Usually part of Rack mounted UTMC OTU). This
router needs to be installed on its side to fit into the rack.
3 Cable tie the provided PSU to the shelf alongside the Router and wire the DC connections
directly onto the terminations of the router.
4 Wire the supplied plug onto the mains lead and plug into the socket on the Modem Rack
(do NOT use the maintenance socket).
5 Terminate the Antenna Cable in the controller where the supplied Antenna Adaptor cable
(SMA to N-Type) will reach between the router and the end of the cable. (See Error! Ref-
erence source not found.)
6 Install the Antenna Adaptor cable between the Antenna cable and the Routers "Primary
Cellular" SMA connector.
IP ROUTERS INSTALLATION GUIDE 3G OTU
667/CI/45025/000 Rev 4 Unrestricted
23