Table of Contents
Advertisement
Transit - Arrived
ONCE / Display-
Statistics
Transit - Arrived
ONCE / NO Display-
Statistics
Display-Statistics
3
ONLY
Disabled (Start &
Config only)
Status: The buttons
are inactive
Data logging
3.4.8.1
34 - EN
LIBERO Tx could be used for one transit - arrived period only!
• To start recording, press the TRANSIT-button for 2 seconds.
• Enables the buttons to mark the start and the arrival of the shipment. Those markings
are visible in the PDF report.
3.4.6.2 Example: PDF report - Transit - Arrived period
• Measurement statistics shown on the display
5.3.2 Statistics
LIBERO Tx could be used for one transit - arrived period only!
• To start recording, press the TRANSIT-button for 2 seconds.
• Enables the buttons to mark the start and the arrival of the shipment. Those markings
are visible in the PDF report.
3.4.6.2 Example: PDF report - Transit - Arrived period
• Measurement statistics shown on the display
5.3.2 Statistics
• To start recording, press the TRANSIT-button for 2 seconds.
Switch to configuration mode for a new setting.
2.3 Start Configuration Mode.
For any button modes, data recording continues till the memory is full. All recorded
data, even the non-visible data in the PDF report, can be evaluated with
elproVIEWER or elproLOG ANALYZE.
Display mode
Allways show current value
All display possibilities are enabled
Don't show current value when in "Arrived" Mode
Never show current value
-
Temperature- or humidity measurement values won't be shown
-
Status information is shown
CONFIGURA TION S OFTW AR E
liberoCONFIG
LI6002Eg
Advertisement
Table of Contents
