Shure Legendary Performance SVX Manual page 11

SVX
Working Range
Note: Actual range depends on RF signal absorption, reflection
and interference.
HI power mode
75 m (250 ft) (Line of Sight)
LO power mode 18 m (60 ft) (Line of Sight)
Audio Frequency Response
50–15000 Hz (Note: Dependent on microphone type)
Modulation
FM, Ref. ±48 kHz deviation with 1 kHz tone
Total Harmonic Distortion
<0.5%
Dynamic Range
90 dB, A-weighted, typical
Operating Temperature Range
-10°C (0°F) to 50°C (122°F) (Note: Battery characteristics
may limit this range.)
Transmitter Audio Polarity
Positive pressure on microphone diaphragm produces positive
voltage on pin 2 (with respect to pin 3 of XLR output) and the tip
of the 6.35 mm (1/4-inch) output.
SVX1
Audio Input Level (maximum)
MIC setting
LINE setting
Gain Adjustment Range
8 dB
Input Impedance
MIC setting
LINE setting
RF Output Power
10 mW (dependent on applicable country regulations)
Dimensions
108 mm x 64 mm x 19 mm (H x W x D)
Weight
90 g (without batteries)
Housing
Molded ABS
Power Requirements
2 "AA" size alkaline or rechargeable batteries
Battery Life
up to 10 hours
−15 to − 7 dBV
1 to 9 dBV
16 kΩ
120 kΩ
SVX2
Audio Input Level (maximum)
−20 dBV
Input Impedance
22 kΩ
RF Output Power
dependent on applicable country regulations
HI power mode
LO power mode
Dimensions
254 mm X 51 mm dia. (10 X 2 in.)
Weight
270 g (10.2 oz.) (without batteries)
Housing
Molded ABS
Power Requirements
2 "AA" size alkaline or rechargeable batteries
Battery Life
up to 10 hours (alkaline)
SVX4/ SVX88
Dimensions
SVX4
32 mm X 168 mm X 104.5 mm
SVX88 32 mm X 256 mm X 104.5 mm
Weight
SVX4 245 g (8.5 oz.)
SVX88
381 g (13.5 oz.)
Housing
Molded ABS
Audio Output Level
Ref. ±48 kHz deviation with 1 kHz tone
XLR connector into 100 kΩ load
6.35 mm (1/4") connector into 100 kΩ load
J9 Audio Output Level
Ref. ±26 kHz deviation with 1 kHz tone
XLR connector into 100 kΩ load
6.35 mm (1/4") connector into 100 kΩ load
Output Impedance
XLR connector
6.35 mm (1/4") connector
Sensitivity
-105 dBm for 12 dB SINAD, typical
Power Requirements
(supplied by external power supply)
SVX4:
12–18 V DC @ 130 mA
SVX88:
12–18 V DC @ 220 mA
10 mW maximum
1 mW maximum
−16 dBV
−22 dBV
−21 dBV
−27 dBV
600 Ω
600 Ω
11