Hobo UA-003-64 Manual

Pendant event / temp data logger

Advertisement

Quick Links

HOBO
Pendant
®
Event/Temp Data Logger
(Part # UA-003-64)
Inside this package:
• HOBO Pendant
Event/Temp
Data Logger
• Tie wraps and
adhesive mount
Doc # 9831-C, MAN-UA-003
Onset Computer Corporation

Specifications

External event input
Event sensor
Maximum input frequency
Lockout time
Minimum pulse width
Input/output impedance
Edge detection
Preferred switch type
Open circuit input voltage
Maximum input voltage
User connection
Temperature measurement
Measurement range
Accuracy
Resolution
Drift
Response time
Logger
Time accuracy
Operating range
Environmental rating
Drop specification
NIST traceable certification
Memory
Materials
Weight
Dimensions
© 2005, 2006 Onset Computer Corporation
Part #: MAN-UA-003, Doc #: 9831-C
Thank you for purchasing a HOBO data logger. With proper care, it
will give you years of accurate and reliable measurements.
The HOBO Pendant Event/Temp Data Logger is a rugged,
weatherproof event logger with a 10
for use with tipping-bucket rain gauges, and can record tens of
thousands of measurements and events. The logger uses a coupler and
optical base station with USB interface for launching and data readout
by a computer.
A base station, coupler, and HOBOware
logger operation. Visit www.onsetcomp.com for compatibility
information.
Two-wire interface suitable for measuring mechanical and electrical contact closures
1 Hz (1 pulse per second)
500 ms
1 ms (hardware debounce)
100 kΩ
Falling edge, contact closure, or Schmitt-trigger buffer
Normally open. For maximum battery life, the event input should be used with its preferred switch type. The
logger will work with normally closed switches, but battery life will be compromised.
Battery voltage; nominally 3.0 V
Battery voltage + 0.3 V
24 AWG, 2 leads: white (+), black (-)
-20° to 70°C (-4° to 158°F)
± 0.47°C at 25°C (± 0.85°F at 77°F), see Plot A. A solar radiation shield is required for accurate temperature
measurements in sunlight.
0.10°C at 25°C (0.18°F at 77°F), see Plot A
Less than 0.1°C/year (0.2°F/year)
Airflow of 2 m/s (4.4 mph): 10 minutes, typical to 90%
± 1 minute per month at 25°C (77°F), see Plot B
-20° to 70°C (-4° to 158°F)
Tested to NEMA 6 and IP67; suitable for deployment outdoors
1.5 m (5 ft) onto concrete
Available for temperature only at additional charge; temperature range -20° to 70°C (-4° to 158°F)
CR-2032 3V lithium battery; 1 year typical use
64K bytes; see "Data storage" on page 3.
Polypropylene case; stainless steel screws; Buna-N o-ring; PVC cable insulation
50 g (1.7 oz.)
71 x 33 x 23 mm (2.8 x 1.3 x 0.9 inches); 1.8 m (6 ft) cable
The CE Marking identifies this product as complying with the relevant directives in the European Union (EU).
bit temperature sensor. It is ideal
-
®
software are required for

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the UA-003-64 and is the answer not in the manual?

Questions and answers

Summary of Contents for Hobo UA-003-64

  • Page 1 ® Event/Temp Data Logger (Part # UA-003-64) Inside this package: Thank you for purchasing a HOBO data logger. With proper care, it will give you years of accurate and reliable measurements. • HOBO Pendant Event/Temp The HOBO Pendant Event/Temp Data Logger is a rugged,...
  • Page 2 HOBO Waterproof Shuttle) USB port on your computer. 3. If you are using the HOBO Waterproof Shuttle, briefly press the coupler lever to put the shuttle into base station mode. 2. Insert the logger and the base station into the coupler, as shown in the following diagrams.
  • Page 3 HOBO Pendant Event/Temp Data Logger Triggered start Data storage This logger can be configured to start at your command, using the The data logger has 64,000 bytes of nonvolatile data storage. Data magnet in the coupler to trigger a start.
  • Page 4 HOBO Pendant Event/Temp Data Logger 2. Examine the desiccant pack that is tucked below the battery Battery holder. If the desiccant is not bright blue, put the desiccant The logger requires one 3 Volt CR 2032 lithium battery. Battery pack in a warm, dry place until the blue color is restored.
  • Page 5 THIS PRODUCT. HOBO products are easy to use and reliable. In the unlikely event that Indemnification. Products supplied by Onset are not designed, intended, or authorized for use as components intended for surgical implant or you have a problem with this instrument, contact the company where you bought the logger: Onset or an Onset Authorized Dealer.

Table of Contents