Wenglor FIS-0870 Quick Start Manual

Quick Start Guide
FIS-0870 Industrial
Sweep Raster Scanner
Step 3 — Position Scanner
1. Place a test symbol in a location with as little ambient light
as possible.
2. Position the scanner at the focal distance used in your application.
3. Align the test symbol with the scanner's field of view.
4. Tip the scanner relative to the test symbol to avoid glare
from specular reflection.
axis
Skew
Bar code
label
Symbol
Scanner
Scan line
Scanner
Step 1 — Check Hardware
Standalone (
Be sure that all connections are secure BEFORE applying power
Caution:
to the system. Always power down BEFORE disconnecting any cables.
Item
FIS -0870 Industrial Raster Scann
1
Interface Device
2
Cordset, Common, M12 12-pin Plug to M12 12-pin Socket, 1 m
3
Cordset, Host, Serial, M12 12-pin Socket to DB9, 1 m
5
Power Supply, M12 12-pin Socket, 1.3 m
6
Cordset, Host, Ethernet, M12 8-pin Plug to RJ45, 1 m
7
Photo Sensor, M12 4-pin Plug, NPN, Dark On, 2 m
8
Note: Additional cordsets and accessories are available in the Microscan Product Pricing Catalog.
P/N 83-110870 Rev B
Step 4 — Install ESP
ESP Software can be found on the wenglor Tools CD that is
packaged with the FIS-0870.
1. Follow the prompts to install ESP from the CD.
2. Click on the ESP icon to run the program.
Tilt
Note: ESP can also be installed from the Download Center at
axis
Tilt
www.
Maximum
skew, tilt,
and pitch:
±30°
Refer to the F - 870 Industrial Raster Scanner User's Manual for
detailed information about using ESP to configure the FIS-0870.
Pitch Pitch
axis
) Standalone (without
Hardware Required
Description Part Number
FIS-0870-XXXX
ZAA12NN01
ZAV12Rx01
ZAV13Rx01
NT-10
ZAV88Rx01
.com.
Step 2 — Connect the System
Important: When connecting Ultra-Lock cordsets to the FIS-0870
and ZAA12NN01, align the pins first and then push the connector into
place. Do not twist the connectors, as this will bend the pins.
Important: Do not attempt to power more than four scanners with
a single power supply in a daisy chain configuration. Add a
ZAA12NN01 and one power supply for every four additional
scanners in the daisy chain.
RS-232
1. Connect the Serial Communication Cable from "A" on the
FIS-0870 to "2" on the AB-0830.
2. Connect the host cable from "1" on the QX-1 to the host computer.
3. Connect the photo sensor to "T" on the ZAA12NN01.
)
4. Connect the power supply to "3" on the ZAA12NN01.
5. Plug in the power supply.
Ethernet
1. Connect the Ethernet Cable from "B" on the FIS-0870 to the
network.
2. Connect the power supply to "A" on the FIS-0870.
3. Plug in the power supply.
Step 5 — Select Model
When you start ESP, the model menu will appear:
1. Click the button showing the FIS-0870.
2. Click OK.
Note: You can also simply double-click the button showing
your scanner to make your selection.
Click Yes when this dialog appears:
3.
Note: If you need to select another model later, click the
Switch Model button near the top of the screen or use
Model > New Model in the menu toolbar.