Page 1
WORLD'S FIRST WATERPROOF KIDS METAL DETECTOR! For the young tre asure hu nte r s of the future… Quick Guide Authorized R&D CENTER...
Page 2
ASSEMBLY The device comes disassembled in 2 pieces. To assemble the device, first remove the small spongy cable protector piece on the middle shaft and dispose it. Next, engage the shafts together so that the screw hole is centered in the slot. Pay attention not to damage the cable during this process.
BATTERY INSTALLATION To install or replace batteries, remove the screw located on the battery compartment cover with a screwdriver. Then, rotate the cover 1/4 turn as shown in the image and pull out. Install the batteries paying attention to (+) and (-) signs as indicated on the sticker. Then, attach the battery compartment cover by reversing the above process and secure by tightening the screw.
Page 4
While Pinpointing: Lights up green when the search coil is over the center of the target. 4) Good Target (Non-ferrous Metals) When a good target is detected, the Mini Hoard will emit a high tone and the smiley face with thumbs up will appear on screen.
Page 5
Large and/or shallow target - Lift the search coil up. Auto Shut-off & Alarm After about half an hour of inactivity, the Mini Hoard will start emitting an audible alarm. After 3 minutes of alarm, the device will shut off automatically to save battery life.
CORRECT WAY OF SWEEPING Wrong search coil angle Wrong search coil angle Correct search coil angle Incorrect way of sweeping Correct way of sweeping It is important to keep the search The search coil must be parallel to coil parallel to the ground in order the ground at all times.
: 2xAA (not included) Warranty : 2 years IMPORTANT! Stickers included in the Mini Hoard Cool Kit are NOT waterproof. Nokta Makro Detectors reserves the right to change the design, specifications or accessories without notice and without any obligation or liability whatsoever.
Page 8
w w w. n o k t a d e t e c t o r s . c o m...