Nokta MAKRO PulseDive User Manual
  1. Manuals
  2. Brands
  3. Nokta MAKRO Manuals
  4. Metal Detector
  5. PulseDive
  6. User manual

Nokta MAKRO PulseDive User Manual

Hide thumbs Also See for PulseDive:

Advertisement

Table of Contents

Advertisement

Table of Contents
loading

Related Manuals for Nokta MAKRO PulseDive

Summary of Contents for Nokta MAKRO PulseDive

  • Page 2: Legal Disclaimers

    The device has been designed with IP68 rating as a waterproof unit up to 60 meters (200ft.). When using the PulseDive underwater or while washing it, one of the coils must be attached! You cannot change the coil underwater! When using the PulseDive in sand, the dust protection cap must be attached to...

  • Page 3: Introduction To The Device

    INTRODUCTION TO THE DEVICE The PulseDive can be purchased in 2 models: Scuba Detector & Pointer 2-in-1 Set and as a stand-alone Pinpointer only. Both models have the same functions and operate the same way. The only difference between them is the scuba coil and some accessories included in the 2-in-1 set.
  • Page 4 ASSEMBLY The PulseDive comes with the scuba coil attached. If you want to use the pinpointer coil, please follow the steps in the pictures. If you want to re-attach the scuba coil, repeat the steps in reverse order. IMPORTANT! When changing coils,...
  • Page 5 ASSEMBLY 3) Hold the pinpointer coil so that the threads are properly aligned. 4) Insert the pinpointer coil into the control unit and push. 5) To attach the pinpointer coil, insert the hard-shell case over the pointer coil and push half-way forward. 6) Then, twist the coil clockwise to tighten.
  • Page 6 (b) to your belt or wrist band. In order to carry the PulseDive on your waist and not to lose it, we recommend you to use the belt holster and the security lanyard as shown in the below picture.

  • Page 7: Battery Information

    Do not expose the device to extreme temperatures (for example a car's trunk or glove compartment) Do not charge the battery in temperatures over 35° C (95° F) or below 0° C (32° F). The PulseDive battery can only be replaced by Nokta Makro Detectors or its authorized service centers.

  • Page 8: Operation Of The Device

    Press the (F) button to change the mode. Red LED In addition to the above detection modes, PulseDive also has a red LED that indicates metal detection. When the red LED is activated, it flashes once upon metal detection regardless of the mode used.

  • Page 9: Led Flashlight

    Press it again to turn off. DIVE MODE If you are diving with the PulseDive, you need to switch the device to dive mode in order to prevent the buttons from being pressed by water pressure. While in the dive mode, the buttons are locked and do not work. Therefore, make sure that the device is set to the desired settings before switching to dive mode.

  • Page 10: Frequency Shift

    LOST ALARM The PulseDive has a lost alarm feature which makes it easier to find the device in case you lose it. If no button is pressed and/or if the device does not detect any targets for 5 minutes, the lost alarm is activated.

  • Page 11: Technical Specifications

    Battery : 1650mAh Lithium Polymer Charging Time : ~ 2 hours Warranty : 2 years Nokta Makro Detectors reserves the right to change the design, specifications or accessories without notice and without any obligation or liability whatsoever. KKPDS-EN-55000347...

Table of Contents