baby&child AVA VANITY Assembly Instructions

PARTS INCLUDED

A [1] Ava Vanity
ASSEMBLY INSTRUCTIONS
1. Unpack all parts and place them on a protected work surface.
2. Determine the final position of the furniture piece. Position the metal bracket (B) on the wall stud approximately 2"
below the metal bracket mounted to the back of the furniture. Mark and drill pilot hole into the center of stud with
3/32" drill bit. Attach metal bracket (B) into the wall by using screws (E) and EZ mini anchors (F). (Detail A)
3. Move the furniture into position with the brackets on the back edge are in line with the brackets in the wall.
4. Insert the clevis pin (C) through holes on brackets and hole on metal cord (A). Using hair pin (D) to go through small
hole on clevis pin (B) to lock it. (Detail B)
5. Repeat above step to attach the end of metal cord (A) to the metal bracket on the wall. (DETAIL B)
6. Check to make sure the metal cord are securely laced and locked to the brackets.

CARE INSTRUCTIONS

To clean, use a damp cloth. We do not recommend using
abrasive or chemical cleaners as they may damage the finish.

IMPORTANT SAFETY INSTRUCTIONS

Place the heaviest items in the lowest drawers.
Do not set TVs or other heavy objects on the top of this product.
Never allow children to climb or hang on drawers, doors or shelves.
baby&child
RESTORATION HARDWARE
AVA VANITY
A
B
C
D
E
F
Page 1 of 2
PARTS
DESCRIPTION
Metal cord
Bracket
�
Clevis pin
�
'
Hair pin
�
Screw M4 x30
Wall plug
�
QTY
1
1
2
2
2
2