IKEA GRILLSKÄR Manual page 7

LEAK TESTS
IMPORTANT – PERFORM LEAK TESTS
BEFORE USE
Always leak test the unit – annually,
when dismantled, when parts are
replaced, or if the gas cylinder is
removed or replaced.
• Never use an open flame to check for
leaks at anytime. DO NOT IGNITE THE
BARBECUE DURING LEAK TESTING.
• To be performed in a well-ventilated
area.
• Be sure all control knobs are in the
'OFF' position.
• Check for leaks by brushing a solution
of 1/2 water and 1/2 soap over all the
gas system joints, including all valve
connections, hose connections and
regulator connections.
• Ensure the soap solution has been
applied to all connections – connect
the regulator to the gas cylinder,
open the gas control valve on the
regulator allowing gas to flow.
• OBSERVE – if bubbles form over any
part of the joints there is a leak.
• Turn off the gas and tighten all joints
• Repeat test. If bubbles form again, do
not use the barbecue. Please contact
your local dealer for assistance.
Gas and Regulator
• The cylinder should be positioned
underneath the main barbecue body
and stored upright.
• Gas cylinders should never be stored
or laid on their side.
User instructions
Before assembling your barbecue,
remove all protective packaging from
each part.
The gas cylinder must have a
connection compatible with the
regulator supplied with the barbecue
and have a minimum capacity of 4kg /
9lbs.
Do not store a spare LP gas cylinder
under or near this appliance.
Never fill the cylinder beyond 80% full.
Failure to follow these instructions
exactly may result in fire causing
serious injury or death.
Place dust cap on cylinder valve outlet
whenever the cylinder is not in use.
Only install the type of dust cap on the
cylinder valve outlet that is provided
with the cylinder valve. Other types of
caps or plugs may result in leakage of
propane.
Connecting to the Cylinder
• Confirm all barbecue control knobs
are in the 'OFF' position.
• Connect the regulator to the gas
cylinder, hand tighten it securely (*)
and proceed according to instructions
below and the instructions from the
gas cylinder supplier.
Cylinders used in USA or Canada
• Are only acceptable for use with the
appliance provided they are
compatible with appliance gas
cylinder retention means. See
illustration within this user manual
depicting correct gas cylinder
retention.
7