Changing Batteries - CICLOSPORT CICLOPULS CP 13is Owner's Manual

Heart rate monitor with 13 functions
Hide thumbs Also See for CICLOPULS CP 13is:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 22
The values vary from person to person and they offer a
valid training support - always staying between 70% and
85% of the maximum heart rate.
(+/- 5% of tolerance, taking into consideration the actual
heart rate when at rest and the level of training).
The question of burning fat is seen in the "correct" light
with CicloInZone - on the basis of the personal data
collected.

7. CHAnGInG BAtteRIes

Information on batteries:
The battery in the CICLOPULS CP13is should last for
approximately 1 year and the battery in the chest belt
should last for approximately 2 years (based on an average
use of 1 hour per day).
CICLOPULS CP13is battery:
The battery can be changed by a watchmaker (preferably
with the help of these instructions), or personally by the
user, if sufficiently dextrous. The tools required are a cross-
point (Phillips) screwdriver and tweezers to handle the
small screws.
n.B.: Changing the battery erases all values and settings.
- Take note of all personalised values and those to be
inserted.
- Place the watch on a clean, non-scratch surface with the
display facing downwards.
- Loosen the four screws and remove the protective base
plate.
- Use a pin to loosen the battery fixing clip on the upper
side.
- Remove the old battery and fit a new CR2032 lithium
battery, with the negative pole facing upwards.
- Relock the battery fixing clip.
- Check that the rubber gasket for the metal cover is still
positioned correctly, to keep the device watertight.
- Replace the protective base plate and fix it with the four
screws (crosswise and without too much force!).
- Check the display, the buttons and the acoustic alarm. If
a button does not work correctly, check that the inner
part has been positioned correctly!
- It can occur that the processor is not correctly reset after
changing the battery. If this happens, meaningless
values, or no values at all, may appear on the display. In
this case, remove the new battery, wait approximately 20
seconds and reinsert the battery.
- Reset the personal values and those to be inserted.
35

Advertisement

Table of Contents
loading

Table of Contents