Advertisement
Before carrying any maintenance, cleaning or check-up work, the plug needs to be
•
pulled from the mains supply and the motor needs to be cooled down. Wait until all
moving parts are standing still.
Keep to the recommendations of this manual regarding the check-up, maintenance and the
•
time frames.
Keep the device in a well maintained condition. If the safety and note labels on the device can-
•
not be read anymore, they need to be replaced.
After the season has finished, the device needs to be cleaned thoroughly, preparing it for the
•
next season. Before using it again, check all components thoroughly.
Check the tines regularly for damage.
•
Always make sure that the ventilation holes are free of dirt.
•
Check whether the extension cables have any sign of damage, before using the device. If the
•
cable seems to be damaged or worn, it needs to be exchanged immediately. Keep the cable
away from the tines.
Ensure that all screws and nuts are tightened, for a smooth and safe operation.
•
Replace damaged or worn parts, to ensure all safety measurements are in place and guaran-
•
teed.
Only use original spare parts, as only these have been authorised and tested by the manufac-
•
turer. Other spare parts can cause unforeseeable damage.
Maintenance service which is more complex or requires the help of special tools needs to be
•
carried out by a qualified technician.
The device needs to be checked-up on at least once per season by a qualified technician.
•
Cleaning
Please clean the device only with a mild soap-water and make sure no water gets into the casing. En-
tering liquids can lead to damages.
Storage
Note!
Wait before the motor has cooled down entirely.
Leave the motor to cool down in an closed room.
•
Exchange damaged or worn-out parts frequently.
•
Store the device in a dry, clean and frost protected area, out of the reach of unauthorised
•
people.
Clean all parts and equipment of the tiller carefully after use (see Maintenance and Care for
•
reference). This will protect the machine from mould.
Do not expose the device to direct sunlight.
•
Cover the tiller with a suitable covering, which will hinder humidity from entering. Do not use a
•
plastic foil as a cover. A non-permeable cover will capture the humidity and will encourage rust
and corrosion.
•
Ensure that the cable is not bend or knotted.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 62419
Page 8
03
2021-1
Advertisement
