Advertisement
Please take note of the instructions in this operating manual before starting the motor.
Do not tilt the device when starting it.
Keep all body parts (especially hands and feet) out of reach of the tiller.
Hold the handles and the switch with both hands during the use of this device.
Note:
If you let go of the switch during use, the engine as well as the blades will stop running.
Stopping the motor
Attention!
The blades will continue turning for a few seconds after switching the tiller of.
1.
Let go of the shift lever, to stop the motor and the blades.
2.
Remove the device from the electricity socket, to avoid an accidental start, when it is not su-
pervised.
Information on the use
Hold the device with both hands at all times and pay attention to your feet, to avoid any acci-
dents from happening. Be cautious when walking backwards, as a risk of tripping exists. Do
not touch the transmission as it can get warm and cause burns!
Damage prevention
Never lift or pull the device when the motor is running.
•
Always lift the device when moving it across hard surfaces, such as tiles or stones. Do not
•
move fast or abruptly.
Switch the device off when finishing the work and disconnect it from the electricity supply for
•
transport. Wait until the blades have stopped rotating.
Move the device through the ground at a normal pace and as upright as possible.
•
Always work away from the socket. Ensure that the cable is kept as far away from the working
•
space as possible. Hang the cable into the belt clip which is included in the delivery.
Overburden protection: The motor of the tiller will switch itself off automatically if it is over-
•
burdened. The device must not be used before the motor has entirely cooled down again.
When working in slopes: Move diagonal to the slope, never from top to bottom. Be especially
•
cautious when changing the direction on the slope. Do not work on overly steep slopes. There
is a risk of injury if the tiller falls over, as well as the risk of the engine damaging due to ineffi -
cient lubrication. The maximum cross slope is 15°.
Working with the device
Keep your hands and feet away from the tiller and its tines at all times whilst working with it
•
and especially when starting it. Otherwise there is a severe danger of injury.
The optimal operating temperature is between 0
•
When working with the tiller, make sure to comply with all your local regulations and including
•
the regulations on noise restriction. The operation of the device can be limited or even forbid-
den on certain days (e. g. Sundays, bank holidays, etc.) or in certain areas (e. g. near hospit-
als, spas, etc.).
Do not use the device, on stones or grass, as the device can be damaged by this.
•
Do not use the tiller in the rain, in bad weather or in humid environments (e. g. near swimming
•
pools or ponds, etc.). Only use the device in daylight or in very good lighting conditions.
Only use the device if you are well focused, not tired and are not under the influence of alco -
•
hol, drugs or medicaments. Always take a break, as soon as you notice you require one.
Pay attention to your balance and ensure you have a stable stand when operating the device,
•
especially in slopes. Do not work on overly steep slopes. If there is the danger of slipping on a
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
℃
and 32
℃
Item 62419
.
Page 6
03
2021-1
Advertisement
