Biostar M7VKG User Manual page 38

Chapter2
Integrated Peripherals
This section page includes all the items of IDE hard drive and Programmed Input/
Output features.
Power Management Setup
This setup page includes all the items of power management features.
PnP/PCI Configurations
This setup page includes IRQ Setting by user define or default.
PC Health Status
This page shows the hardware Monitor information of the system.
Frequency/Voltage Control
This page shows the hardware Monitor information of the system.
Load Fail-Safe Defaults
Use this menu to load the BIOS default values for the minimal/stable performance
for your system to operate.
Load Optimized Defaults
These settings are more likely to configure a workable computer when something
is wrong. If you cannot boot the computer successfully, select the BIOS Setup
options and try to diagnose the problem after the computer boots. These settings
do not provide optimal performance.
Set Supervisor Password
Change, set, or disable password. It allows you to limit access to the system and
Setup, or just to Setup.
Set User Password
You can specify both an User and a Supervisor password. When you select either
password option, you are prompted for a 1-8 character password. Enter the
password and then retype the password when prompted.
Save & Exit Setup
Save CMOS value changes to CMOS and exit setup.
Exit Without Saving
Abandon all CMOS value changes and exit setup.
2-4
BIOS Setup