Table of Contents
Advertisement
iQ4Bike base
Using several iQ4Bike bases
3. Disconnect the first installed iQ4Bike base from USB cable.
4. Wait until the second iq4bike tool has been connected to the second iQ4Bike base.
5. Repeat steps 2-4 for all additional iQ4Bike bases.
6. If all iQ4Bike bases have been installed at the PC and connected to the relevant iq4bike
diagnostic tool, each iQ4Bike base that was previously disconnected must be re-
connected using a USB cable.
All iQ4Bike bases have now been installed at the PC, connected to an iq4bike diagnos-
tic tool and can exchange information with the PC.
Installation and connection
C-3
Advertisement
Table of Contents
