Related Manuals for global lift corp COMMERCIAL Series
Summary of Contents for global lift corp COMMERCIAL Series
- Page 1 COMMERCIAL SERIES LIFTS C-375/C-450 RETRO-FIT ANCHORING METHOD INSTALLATION MANUAL Feb 2012 RETRO-FIT/COMMERCIAL SERIES...
- Page 2 RETRO-FIT ANCHORING METHOD C-375/C-450 COMMERCIAL SERIES LIFTS PACKING LIST • 3 – Threaded Anchor’s with base • 3 – 5/8” Nuts • 3 – 5/8”x 1” Bolts • 3 – Bonding lugs w/nut & bolts • 3 – Plastic Caps •...
- Page 3 12 inches (305 mm) behind the rear edge of the seat. The clear deck space shall have a slope not steeper than 1:48. •Submerged Depth. The lift shall be designed so that the seat will submerge to a water depth of 18 inches (455 mm) minimum below the stationary water level. RETRO-FIT/COMMERCIAL SERIES Feb 2012...
- Page 4 • The dimensions are as follows: Front of the Template must be 12” to 17” from the water’s edge, also make sure that the front holes are parallel to the pools edge. ***NOTE: The installation of Global Lift Corp’s anchor system’s are a guideline of minimum requirements. In some states or municipalities they may require additional steps due to their local codes or ordinances.***...
- Page 5 Out the debris and make the holes are free from concrete. Double check your measurements they should be: Front holes 8” from centerline from hole to hole (see above). The measurement from front to back should be 15” from Centerline of each hole (see above) Feb 2012 RETRO-FIT/COMMERCIAL SERIES...
- Page 6 • Place the assembly in your drilled holes as shown in picture B. make sure that the top Of the anchor rods are flush and level with the existing concrete, also with connecting the Bonding lugs to the bonding grid according to the local codes and ordinances Feb 2012 RETRO-FIT/COMMERCIAL SERIES...
- Page 7 • Let the concrete set for 24hrs, Remove the template then sand the area with a sand stone to smooth the finish. Make sure the anchor’s are flush with the concrete (picture B) • You are now ready to install your Commercial Series lift. Feb 2012 RETRO-FIT/COMMERCIAL SERIES...
Need help?
Do you have a question about the COMMERCIAL Series and is the answer not in the manual?
Questions and answers