Hitachi iH-210 User Manual page 6

Warning
Hitachi Terminal Solutions Korea Co., Ltd.
iH-210 User Guide
Installation
1. At installation and relocation of the products, please contact our distributor near
you or our designated dealers. If installation is not perfect, there is a risk of a falling
accident, electric shock, fire, or burn injury.
2. At installation and use of the products, keep the space sufficient for opening and
closing the door, cover and operation. If a part of the product touches a human body
incorrectly, it may cause an accident.
3. In case of installing the product at the following places, you should confirm the
Road Law, Road Traffic Law and Fire Protection Law, etc. If compliance conditions
are not clear, please consult with the authorities concerned.
- The place which may disturb traffic or accident prevention.
- The place adjacent to the fire extinguishing and detecting apparatus.
- The place adjacent to the road signs or traffic signals.
- The place where combustible materials or gas are treated (gas stations, etc.)
Passages and facilities for evacuation Illegal installation may cause an accident.
4. Keep an installation space as described in the instruction manual, and do not
block or close the ventilation inlet. If the ventilation inlet is blocked, heat is
accumulated inside and it may cause fire.
5. Depending on the installation place, mounting of an earth leakage breaker is
required by Electricity Enterprises Law. Illegal installation may cause an accident.
1. Do not install the product in any place where water may spill on it. If water enters
into the product, insulation performance degrades and it may cause fire and/or
electric shock.
2. Do not install the product at the place where the floor cannot bear the load of the
product, or at any unstable place with inclination and/or irregularity. It may cause
floor caving and sudden movement accidents of the product to occur.
3. Installation at the following places should be avoided:
- 1m or less from volatile combustible materials or curtains.
- 1m or less from heating apparatus such as stoves, heaters etc.
- Any place with direct winds blown from air conditioners, ventilating openings
etc.
- There are safety problems and deterioration of the product may be
accelerated, which leads to any cause for failure.
6