Connecting The Water Supply Hose - LG T2525NTWV Owner's Manual

Then tighten the four lock nuts. All lock nuts
must be tightened.
NOTE
• The Mini Washer will not work as a standalone
unit.
Connecting the Water
Supply Hose
Needed Accessories
a Water Supply Hose(for cold water)
Connecting Supply Hose
b
Water Supply Hose Connector
c
Note for Connection
• Water pressure must be between 100 kPa and
800 kPa (1.0 – 8.0 kgf/cm²). If the water
pressure is more than 800 kPa, a
decompression device should be installed.
• Periodically check the condition of the water
supply hose and replace the water supply hose
if necessary.
NOTE
• If the water pressure is near or over 800 kPa, a
water pressure reduction device should be
installed to both taps.
• Exceeding 65 °C can damage some clothes.
• Temperatures below 4 °C can cause hoses to
freeze and burst and unfavourable wash results
due to undissolved detergent.
• Cold inlet Water Temperatures over 25 °C can
cause damage to clothes such as delicate
Woollens
• Do not overtighten the water supply hose or use
mechanical devices to tighten onto the inlet
valves.
• No further backflow protection required for
connection to the water inlet.
Checking the Rubber Seal
Two rubber seals are supplied with the water
a
supply hose. They are used to prevent water leaks.
Connection to taps is sufficiently tight.
• Do not use mechanical devices such as multi
grips to tighten the water supply hose. Ensure
that the curved end of the water supply hose is
connected to the appliance.
INSTALLATION
13