LG T2525NTWV Owner's Manual page 16

2
Remove the guide plate
to fit the adapter.
3
Push the adapter onto the end of the tap so
that the rubber seal is connected to be
watertight. Tighten the 4 fixing screws and the
adapter ring plate.
4
Pull the connector latch plate
the inlet hose onto the adapter, and release the
connector latch plate. Make sure the adapter
locks into place.
NOTE
• After connecting the water inlet hose to the
water tap, turn on the water tap to flush out
foreign substances (dirt, sand, sawdust, and etc.)
if the tap is too large
e
down, push
f
in the water lines. Let the water drain into a
bucket, and check the water temperature.
Connecting the Cold Supply
Hoses to Both Washing
Machines
1
Connect one end of the cold water supply hose
connector to the cold water supply hose of the
Main Washer first. Open the accessory package
for the Mini Washer installation accesories.
2
Connect the water supply hose of Mini Washer
to the COLD water supply hose connector.
3
Connect the additionally provided water supply
hose of Main Washer to the cold water supply
hose connector and cold water tap.
INSTALLATION
15