Connecting The Water Supply Hose; Note For Connection; Checking The Rubber Seal - LG WV6-1410G Owner's Manual

global_main.book.book Page 17 Tuesday, December 6, 2022 8:07 AM
3
Place the adhesive side
sheets on the floor.
• The most effective way is to install the anti-
slip sheets under the front feet. If it is
difficult to place the sheets under the front
feet of the appliance, attach them under the
rear feet.
4
Put the appliance on the anti-slip sheets.
• Do not attach the adhesive side
slip sheets to the feet of the appliance.
NOTE
• Additional anti-slip sheets are available at LG
Electronics service centre.
Connecting the Water
Supply Hose

Note for Connection

• Water pressure must be between 100 kPa and
800 kPa (1.0 – 8.0 kgf/cm²). If the water pressure
is more than 800 kPa, a decompression device
should be installed.
• Periodically check the condition of the water
supply hose and replace the water supply hose if
necessary.
NOTE
• If the water pressure is near or over 800 kPa, a
water pressure reduction device should be
installed to both taps.
• Exceeding 65 °C can damage some clothes.
• Temperatures below 4 °C can cause hoses to
freeze and burst and unfavourable wash results
due to undissolved detergent.
a
of the anti-slip
a
of anti-
INSTALLATION
• Cold inlet Water Temperatures over 25 °C can
cause damage to clothes such as delicate
Woollens
• Do not overtighten the water supply hose or use
mechanical devices to tighten onto the inlet
valves.
• No further backflow protection required for
connection to the water inlet.
• Ensure the inlet hoses are not bent, kinked or
tangled as this could cause insufficient water
flow and result in a malfunction.

Checking the Rubber Seal

a
Two rubber seals are supplied with the water
supply hose. They are used to prevent water leaks.
Connection to taps is sufficiently tight.
• Do not use mechanical devices such as multi
grips to tighten the water supply hose. Ensure
that the curved end of the water supply hose is
connected to the appliance.
17