Advertisement
Make the dump unit from F9 and 3x3 spruce and the servo blocks , adjust them for your servo, glue
canopy closing with epoxy to F9 , solder a ,22 mm ring to the canopppy closing arm to hold the
steering wire , bend this from 1,2mm steel , test all do test fit for free movement of the servo and
fasten to fuselage with the 2,9x13mm fasteners
Place the pre bend axel to the cross and fasten with the landing gear straps and fasten with the 2,9x13
fasteners, yu might need some fitting and sanding before it is working ok
Motor cowl:
Place the cowl former F1 on approx 9-10mm balsa scrap place cowl over it and it should fit with
minimum play between former and cowl , if not adjust until good fit , glue with ca and cut flat
Place M4 sunk head nylon fasteners into F2 you might shorten them a bit.
Advertisement
