Section 5. Installation And Setup - Biostar K8NHA Pro Manual

Biostar k8nha pro motherboard: supplementary guide

Hide thumbs Also See for K8NHA Pro:

Table of Contents

BIOSTAR Motherboard

ection 5. Installation and Setup

Module, and also how to set up jumpers and all the information

about the components on the motherboard. Not only can you find

the installation steps, but also the details and locations of the

components on the motherboard.

1. CPU Installation

you are installing the CPU, make sure the CPU has a cooling fan attached on the right

to prevent overheating. If you do not find the cooling fan, contact your dealer and make

sure to install them before turning on the computer.

Step1: Pull the lever sideways away from the socket and then raise the

Step2: Look for the white dot/cut edge. The white dot/cut edge should

Step3: Hold the CPU down firmly, and then close the lever.

Step4: Put the CPU fan on the CPU and buckle it. Connect the CPU fan

Step 1

2 Central Processing Unit: CPU

These fan headers support cooling fans built in the computer. Orient the fans to

make the heat sink fins to allow air flow to go across the onboard heat sinks instead of

the expansion slots. The fan wiring and plug may be different according to the fan

manufacturer. Connect the fan fable to the connector while matching the black wire to

the ground pin.

12 12 12 12 12

English

In this section, you will learn how to install the CPU, DDR

The motherboard supports the AMD Athlon 64

lever up to a 90-degree angle.

point towards the lever pivot. The CPU will fit only in the cor-

rect orientation.

power cable to the JCFAN1. This completes the installation.

Step 2

(1) CPU Fan Headers: JCFAN1

Socket-754 processor. When

Step 3

Assignment

Ground

+12V

FAN RPM Sense

Step 4

Table of Contents