Table of Contents
Advertisement
5.
Tubing filled with mediums with very high or low working temperatures are to be insulated with suitable
materials to avoid burn or scald injuries caused by contact.
6.
As fire prevention, fire dampers are to be provided where ducts cross firebreaks. Local fire prevention code is to
be observed carefully.
Sound power levels
To avoid death, injury, equipment or property damage, the following recommendations should be observed during
maintenance and service visits:
Discharge
1.
The maximum allowable pressures for system leak testing on low and high pressure side are given in the
chapter "Installation". Always provide a pressure regulator.
Measurement conditions:
2.
Disconnect all power supply including other energy sources (gas, air, ...) before any servicing on the unit.
Measurements taken in a room adjacent to the room containing the FWD, at the outlet of the rectangular duct (1.5 m
3.
The Air Handling Unit control system must guarantee that in case of breakdown or power interruption during
long) fixed to its discharge opening.
maintenance or repair work, the unforeseen start-up of a shut off unit is impossible.
4.
Service work on the air handling unit and the electrical system should be carried out only by qualified and
Fan
experienced personnel.
Unit
speed
1
5.
For inspection on the Air Handling Units and to avoid risks, the units surroundings are to be sufficiently lighted.
FWD 08
2
3
6.
Any components which contain refrigerant shall be handled only by Authorized personnel. The refrigerant shall
1
be always recovered before any intervention on such component or before the end of life of equipment. The
FWD 10
2
recovered refrigerant shall be disposed accordingly.
3
1
Any component; chemical or full equipment replaced shall be sorted and disposed in accordance with the
FWD 12
2
appropriate local regulations.
3
1
7.
Where units are installed in areas with high temperature and/or high humidity, the risks of external condensation
FWD 14
2
on the casing have to be considered, especially when the internal air stream temperature is relatively low. Please
3
contact your local Trane sales office to evaluate the potential condensation risks.
1
FWD 20
2
3
Reception
Intake
On arrival, inspect the unit before signing the delivery note.
Reception in France only:
Measurement conditions:
In case of visible damage: The consignee (or the site representative) must specify any damage on the delivery
Measurements taken at the horizontal air intake.
note, legibly sign and date the delivery note, and the truck driver must countersign it. The consignee (or the site
representative) must notify Trane Epinal Operations - Claims team and send a copy of the delivery note. The customer
Fan
(or the site representative) should send a registered letter to the last carrier within 3 days of delivery.
Unit
speed
1
Note: for deliveries in France, even concealed damage must be looked for at delivery and immediately treated as
FWD 08
2
visible damage.
3
1
Reception in all countries except France:
FWD 10
2
3
In case of concealed damage: The consignee (or the site representative) must send a registered letter to the last
1
carrier within 7 days of delivery, claiming for the described damage. A copy of this letter must be sent to Trane Epinal
FWD 12
2
Operations - Claims team.
3
1
FWD 14
Warranty
2
3
1
Warranty is based on the general terms and conditions of the manufacturer. The warranty is void if the equipment is
FWD 20
2
repaired or modified without the written approval of the manufacturer, if the operating limits are exceeded or if the
3
control system or the electrical wiring is modified. Damage due to misuse, lack of maintenance or failure to comply
with the manufacturer's instructions or recommendations is not covered by the warranty obligation. Corrosion
is not covered by the warranty obligations. If the user does not conform to the rules of this manual, it may entail
cancellation of warranty and liabilities by the manufacturer. Electrical motors are factory-tested and properly run
when leaving the factory. Any wiring faults on motors will cause damage for which Trane cannot be held responsible.
AH-SVX03C-GB
UNT-PRC002-GB
Power level in dB(A), per Hz frequency band
125
250
500
55
50
42
57
54
47
58
57
50
57
51
45
58
54
48
60
58
50
57
51
45
58
54
48
60
58
50
56
62
50
61
66
55
63
69
58
57
63
51
61
66
55
63
69
58
Power level in dB(A), per Hz frequency band
125
250
500
56
55
55
63
62
60
66
65
63
62
58
55
66
63
60
70
67
63
62
58
55
66
63
60
70
67
63
66
65
65
73
72
69
78
76
73
68
72
64
76
76
68
78
79
71
General information
1000
2000
4000
37
37
31
40
30
38
42
32
40
42
34
33
45
38
39
48
40
42
42
34
33
45
38
39
48
40
42
48
39
38
53
47
46
56
50
50
49
40
39
53
47
46
56
50
50
1000
2000
4000
53
46
45
60
53
53
62
56
55
58
51
48
62
56
55
65
59
59
58
51
48
62
56
55
65
59
59
65
57
50
71
64
59
75
69
64
64
56
52
71
65
61
74
69
66
Overall power
8000
dB(A)
30
46
40
50
43
53
28
48
35
51
39
54
28
48
35
51
39
54
36
56
45
60
49
63
37
57
45
60
49
63
Overall power
8000
dB(A)
42
57
53
64
57
67
44
61
52
66
57
69
44
61
52
66
57
69
46
68
57
74
63
78
50
69
61
75
66
78
1 1
5
- Quick Links:
- General Information
- Dimensions ( Lxwxth)
Hide quick links:
Advertisement
Table of Contents
