G-U BKS B-1993 Series Installation Instructions Manual page 37

3.2 Installation
B 5490 0308
B-54900-01-4-9
Fig.3: Installation overview
y y Pull the swarf guard ring onto the connection cable. Then fully insert the plug of the connection
cable into the socket at the lock. Pull the swarf guard over the plastic connecting clip (see Fig.).
Secure the connection cable using a cable tie to the connecting clip provided.
y y Guide the lock from below at an angle into the lock recess, stowing the connection cable inside
the profile as you do so.
Make sure that the connection cable is not buckled or in tension and the upper vertical rod
NOTE
B 9006 runs without friction!
y y The copper-coloured transport securing devices on the triggers should remain in place until the
door system is installed in its final location.
B 5490 0300
~50 mm
B-1993x
B-19xxx /
SECURY 19
37