Polygroup SUMMER WAVES 15' Owner's Manual page 8

Oval frame pool (4.57m-6.1m)
Table of Contents

Advertisement

Available languages

Available languages

6. Now insert the two U-Shape pipe sections through the end of the two rectangular strips at the bottom of the pool FIG. 3. Now, insert the capped ends of the U-Shape
pipe into the holes inthe Horizontal Beam assembly FIG. 3 depress the buttons pushing the Cap entirely intothe horizontal beam until it stops.
7. Make sure both U-Shape pipes are insertedfully and check that all connected sections are still securely fastened. Repeat steps for the frame on the opposite side
of the pool.
4
5
Rectangular Strip
At Bottom Of Pool
8. Inflate the top ring. Squeeze the base of the valve stem to open an internal check valve while inflating.
9. Followingtheinstructionsunder"PowerFilterInstallation"inthe"SwimmingPoolFilterSystem"owner's
manual, install Pool Wall Fittings (16-21) as described in Steps "A" - "C". Plug both Pool Wall Fittings (16)
from the inside of the pool using two WallFitting Plugs (20). Make sure the drain fitting is plugged securely
and the cap is in place. Start filling the pool with water. After about 1-inch of water is on the bottom, stop
filling and smooth wrinkles out of the bottom of the pool. Pull the outer wall out from under the top ring,
all around the bottom of the pool, so that it fills evenly.
10. NOTE:IFMORETHAN1-2INCHESOFWATERCOLLECTSONANYONESIDEBEFORETHEPOOL
STARTS FILLING IN THE CENTER, THE POOL IS NOT LEVEL ENOUGH, AND MUST BE CORRECTED,
SEE "SITE PREPARATION", PAGE 4.
NOTE:
THE WEIGHT OF THE WATER WILL PREVENT ANY ADJUSTMENT AFTER THIS POINT.
11. Now, as you continue filling, the inflated ring will rise as the water deepens. Max. Water Level is the bottom
seam of the inflatable ring, this information is printed on the ring. Once this is done, refer back to the
"Swimming PoolFilterSystem" owner's manual, andcontinuethroughtherest of theinstallation.
Return
8
Horizontal Beam Assembly
Deflated Top Ring
Sleeve
1
FIG.3
1
Intake
Insert
As
Shown
U-shape Pipe Section
Shown Inserted Thru
Rectangular Section
At Botton OfPool
IF YOUR POOL INCLUDED A
FILTER/PUMP SYSTEM, REFER
TO FILTER SYSTEM OWNER'S
MANUAL SECTION
IN THE SWIMMING
POOL FILTER SYSTEM
OWNER'S MANUAL, ON PAGE 4,
INSTALL POWER FILTER AND THE
POOL WALL FITTINGS AS
DESCRIBED

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Summer waves 20'

Table of Contents