Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Ronix 2800
Summary of Contents for Ronix 2800
- Page 1 DEMOLITION HAMMER 7.5KG 2800...
-
Page 2: Specifications
SPECIFICATIONS Model 2800 Power 1300W Voltage 220V Frequency 50Hz Impact Energy Max Impact Rate 2400 BPM Weight 7.5kg SDS MAX 25x350mm Flat chisel SDS MAX 25x350mm Point chisel Accessories Grease tube 100g Wiping cloth Before using this demolition hammer, please carefully read though these HANDLING INSTRUCTIONS. -
Page 3: General Power Tool Safety Warnings
SAFETY SYMBOLES In this operator’s manual / or machine’s labels following symbols are used: Read the manual carefully. Accordance with essential applicable safety of European directives. Double insulation. Wear ear and eye protection. Denote risk of personal injury, loss of life or damage to the tool in case of nonobservance of the instruction in this manual. -
Page 4: Work Area Safety
WORK AREA SAFETY - Keep work area clean and well lit. Cluttered and dark areas invite accidents. - Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Power tools create sparks which may ignite the dust or fumes. - Page 5 inattention while operating power tools may result in serious personal injury. Use safety equipment. Always wear eye protection. Safety equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. - Avoid accidental starting.
- Page 6 Use of the power tool for operations different from intended could result in a hazardous situation. SERVICE - Have your power tool serviced by RONIX service qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained.
- Page 7 POWER TOOL-SPECIFIC SAFETY RULES 1) When working with the power tool, always hold it firmly with both hands and provide for a secure stance. The power tool is guided more secure with both hands. 2) Secure the workpiece. A workpiece clamped with clamping devices or in a vice is held more secure than by hand.
-
Page 8: Residual Risks
RONIX service organization. RESIDUAL RISKS Even when the power tool is used as prescribed it is not possible to eliminate all residual risk factors. The following hazards may arise in connection with the power tool’s construction and design: - Injuries and damage to property to due to broken accessories that are suddenly dashed. -
Page 9: Auxiliary Handle
cord of sufficient thickness and rated capacity. The extension cord should be kept as short as practicable. ASSEMBLY AUXILIARY HANDLE Operate your power tool only with the Side Handle. The Side Handle can be set to any position for a secure and low-fatigue working posture. -
Page 10: Starting Operation
REMOVING Push back the Protective lining and remove the tool. OPERATION STARTING OPERATION Observe correct mains voltage! The voltage of the power source must agree with the voltage specified on the type plate of the power tool. Press down the trigger, then the machine is on. Release the trigger, then the machine is off For low temperatures, the power tool reaches the full impact rate only after a certain time. -
Page 11: Warranty
Faulty and /or discarded electrical or electronic apparatus have to be collected at the appropriate recycling location. CAUTION: Repair, modification and inspection of RONIX Power tools must be carried out by a RONIX Authorized Service Center. In the operation and maintenance of power tools, the safety regulations and standards prescribed in each country must be observed.
Need help?
Do you have a question about the 2800 and is the answer not in the manual?
Questions and answers