Billion BiPAC 7402G User Manual page 85

been lost or not. It only follows the policy of Disconnection time after no traffic, which the remote
IPSec will be disconnected after the time you set in this function.
PING: This mode will detect the remote IPSec peer has lost or not by pinging specify IP address.
Dead peer detection (DPD) is a keeping alive mechanism that enables the router to
DPD:
be detected lively when the connection between the router and a remote IPSec peer has lost.
Please be noted, it must be enabled on the both sites.
PING to the IP: It is able to IP Ping the remote PC with the specified IP address and alert when the
connection fails. Once alter message is received, Router will drop this tunnel connection. Re-establish
of this connection is required. Default setting is 0.0.0.0 which disables the function.
Interval: This sets the time interval between Pings to the IP function to monitor the connection status.
Default interval setting is 10 seconds. Time interval can be set from 0 to 3600 second, 0 second
disables the function.
Ping to the IP
xxx.xxx.xxx.xxx (A valid IP Address)
xxx.xxx.xxx.xxx(A valid IP Address)
Disconnection Time after no traffic: It is the NO Response time clock. When no traffic stage time is
beyond the Disconnection time set, Router will automatically halt the tunnel connection and re-establish it
base on the Reconnection Time set. 180 seconds is minimum time interval for this function.
Reconnection Time: It is the reconnecting time interval after NO TRAFFIC is initiated. 3 minutes is
minimum time interval for this function.
Click Edit/Delete to save your changes.
Chapter 4: Configuration
0.0.0.0
0.0.0.0
3G / ADSL2+ (802.11g) (VPN) Firewall Router
Interval (sec)
0
2000
0
2000 Yes, activate it in every 2000
Ping to the IP Action
No
No
No
second.
84