Initial Setup; General Operation - JVC LT-28HA82U Manual

Getting Started

Initial setup

1. Connect one end of the RF coaxial cable to
the aerial socket on the wall and the other end of
your TV.
2. Connect the mains cable to the mains socket
after you have completed all the connections.
3. With power cord plug connected to the mains
power socket and TV in 'Standby' mode.At this
stage, the TV switches to standby mode. The red
LED indicator will illuminate on the front panel of
the TV.
4. In standby mode, press the " " button on
the side of the TV or the
control to turn the TV on. The red LED indicator
will turn blue.
5.
straight into First Time Setup menu. Press
the buttons to navigate the menu and
change the settings.
First Time Setup
OSD Language
Mode Setting
Country
Tuner Type
Auto Scan
LCN
Auto Channel Update
Start
Move Adjust
OSD Language
Selects your desired language to be displayed
on the menu. The default on-screen menu
language is set as English.
Mode Setting
Selects your desired mode setting.
higher than home mode.
Country
Selects the country where you will operate the
TV. The default country is set as France.
Tuner Type
Auto Scan
ATV.
button on the remote
English
Home Mode
France
Cable
DTV+ATV
On
Off
MENU: Return EXIT: Exit
Initial setup
LCN
Select LCN Type On or Off.
Auto Channel Update
Select Auto Channel Update Type On or Off.
Start
Press the ENTER button to start auto tuning.
Auto Scan will commence. The display will show
the progress of the tuning and the number of
channels found.
Auto Scan
Scanning CH34
Digital Channels Found:
DTV :10 Radio :0 Data:0
Analog Channels Found: 0
6. If you want to skip the DTV tuning, press the
MENU button to interrupt the tuning half way.
repeat the above step if you also want to skip the
ATV tuning.

General operation

Press the SOURCE button on the remote control
and select DTV to switch the TV to Digital
Terrestrial Television Broadcasting.
Information Banner
Whenever you change channel using the CH
/ CH buttons or the number buttons, the TV
displays the broadcast picture along with an
information banner on the top left of the screen
(available only in DTV/ATV mode)
The information banner can be displayed a any
time while watching TV by pressing the DISPLAY
button on the remote control.
MENU: Skip EXIT: Exit
13