Orbit Reader 40 User Manual page 81

Orbit Reader 40 – User Guide
section. Assuming no errors, the program displays the message, "Note:
Connect the device to the PC and put it into upgrade mode. To enter,
Firmware Upgrade Mode, press and hold the Right Panning forward
button + 'Dot 5' key. Then press and release the 'Dot 8' key. The other
keys can be released after this" in the message field.
4. Press and hold down the Right Panning forward button + Dot 5, then press
Dot 8. The utility shows the message "Orbit Reader 40 is connected" in
the Device status field. It shows the message "Do you want to upgrade the
device?" in the message field at the bottom of the dialog.
5. Release Dot 8 first, then release the Right Panning key and Dot 5. This
switches the Orbit Reader 40 to Upgrade mode. You should hear a tone
on your PC.
6. The utility shows the device serial number and the software version of the
device at the top right corner of the window. If the serial number is blank,
repeat steps 4 and 5.
7. Activate the Browse button found in the dialog.
8. Browse and select the firmware bin file or audio bin file from your PC. The
file is in the folder you unzipped previously.
9. Once the file is selected, the dialog shows the software version of the
selected file. A dialog box will also display the information whether
Orbit Research
Version 1.3
81