Rowenta EP7212 Instruction Manual page 16

4.
• Cleaning the shaving head (according to model)
- Stop and unplug the device.
- Remove the protective hood (19).
To do so: press the release buttons and pull upwards. You will
remove the protective hood (19) from the blade block (18).
- Carefully remove the hairs by blowing on and around the micro grid (15)
Never use the small brush for cleaning the micro grid (15).
You can also run the protective hood (19) and the blade block (18)
under running cold water to remove all the hair. Shake the parts well
and then dry them using a towel without pressing down on the
micro grid before reassembling them.
- Put the protective hood (19) back on the blade block (18).
You will hear a click.
DO NOT PRESS ON THE MICRO GRID WHEN PUTTING IT BACK INTO PLACE.
Do not apply alcohol to the body of the appliance in order to avoid damaging its colours.
Do not use a metal or sharp tool.
• Clean the trimmer head (according to model)
Stop the appliance and unplug it.
Press the release button to remove the epilator head.
Remove the comb and clean hair from the trimmer head with the
brush.
Rinse the trimmer head under cold tap water for 5 or 10 seconds.
Shake the trimmer head vigorously and dry it with a towel.
IMPORTANT Systematically clean the appliance's trimmer head after each use.
The appliance must not be submerged in water. It must not be used in the shower or bath.
• Cleaning sensitive
areas accessory
4. Shake the epilator head vigorously and
dry it with a towel before fitting it to the
epilator again.
You can also use the small cleaning brush
supplied.
14