PROCONCEPT PLG375 Operator's Manual page 7

!
Gas filler cap
Fig. 4
!
!
Grass box hooks
Fig. 5
Grass Box
Mounted on
the Hook
Fig. 6
OPERATING INSTRUCTIONS
3. Replace, but do not screw back in place, and remove again.
4. The oil level must be between the min and max marks on the dipstick.
5. If necessary, add oil pouring in slowly.
6. Replace the dipstick and tighten.
FILLING THE GASOLINE
WARNING: Gasoline is highly flammable and extreme precautions must be
taken when handling or working with it. Gasoline should only be stored in
approved containers. Never buy, or store more than 30 days supply of gasoline.
DO NOT mix oil with gasoline.
Clean the area around the gas filler cap before removing the cap. Remove the
warning label from under the gas cap. Always use fresh, clean, unleaded gasoline
and fill the tank using a clean funnel.
IMPORTANT: Always leave at least 13 mm below the bottom of the filler neck to
allow for expansion.
Clean up any overflow or splashes of gas before starting the engine. Do not fill the
tank indoors, or in a poorly ventilated area. Gasoline fumes are inflammable and
dangerous. Never open the fill cap, or fill the tank, if the engine is still hot after use.
Do not smoke when filling the tank, using the machine, or when gasoline is present
in the work area. Ensure that you securely tighten the filler cap after filling.
FITTING THE GRASS BOX (Fig. 5 - 6)
To fit the grass box, lift the grass discharge flap and locate the grass box on the
hooks provided on the deck of the machine.
IMPORTANT: Always fit the grass box before starting the engine.
IMPORTANT: Before emptying the grass box, or adjusting the cutting height,
ensure that the engine is switched off and the spark plug cap is disconnected.
7
v.080227