Folding The Handle - PROCONCEPT PLG375 Operator's Manual

ASSEMbLY
UNFOLDING THE HANDLE (Fig. 0 - 1)
WARNING: Folding or unfolding the handle improperly may cause serious
damage to the cables, causing an unsafe operating condition.
Do not damage the cables when folding or unfolding the handle.
1. Carefully move the upper handle up until the handle halves are in line and nest
with the lower handle bracket.
2. Once the handles brackets are in line, lock the handle locking lever.
ATTACHING THE LOWER HANDLE (Fig.2)
1. To attach the lower handle, use a wrench to remove the four bolts.
2. Place the lower handle in position and replace the four bolts. Use the wrench to
retighten the nuts.

FOLDING THE HANDLE

1. Release the locking handle lever.
2. Carefully fold the upper handle down towards the mower.
OPERATING INSTRUCTIONS
BEFORE STARTING THE ENGINE
IMPORTANT:The following procedures and adjustments must be performed
BEFORE the engine is started. Do not attempt to make any of these
adjustment while the engines running.
FILLING THE OIL (Fig. 3)
IMPORTANT: The mower is supplied with no oil in the engine. It is essential that
oil be added before starting the engine for the first time.
To add oil to the lawnmower:
1. Remove the warning label from under the dipstick.
2. Remove the dipstick and slowly pour 600 ml of SAE30 engine oil into the
engine via the oil filler.
3. Replace the dipstick and tighten.
Before each subsequent use, the oil level must be checked and if necessary
topped up with SAE30 engine oil.
1. With the lawnmower on level ground, unscrew and remove the oil lever
dipstick.
2. Wipe oil lever dipstick on a clean rag.
6
PLG375b
!
Fig. 0
Fig. 1
Fig. 2
!
!
Dipstick and
oil filler
Maximum
Fig. 3
Minimum