Maintenenace; Troubleshooting; Recommended Fluid - Ultratec Ultra Handy Fogger Operator's Manual

Maintenance
Exterior
The casing of the Ultra Handy Fogger is steel with a powder paint coating. To clean simply wash with mild soap
and warm water. Ensure the power is disconnected when cleaning!!!
Heat Exchanger
Using high quality Ultratec fluid should result in a long heat exchanger life. (See warranty policy later in this
manual).

Troubleshooting

Not Powering Up
1) Check power cord is securely inserted into Fused Power Entry Module and connected to an appropriate
power source.
2) Check that fuse inside Fused Power Entry Module is not open / blown.
Replace fuse if open.
3) Check that unit has not over heated and caused the thermal disc to trip open and shut power down. This should
automatically reset after about 1/2 hour. Unit needs to be monitored to see if it shuts down again. If it does
contact Ultratec Special Effects Service Department.
Not Heating
1) Check all the same suggestions as not powering up.
Otherwise contact Ultratec Special Effects Service Department.
Not Producing Fog
1) Check that fluid is in fluid tank.
Add fluid if missing.
2) Fluid line is not primed.
Press fluid plunger assembly a number of times to prime line.
Otherwise contact Ultratec Special Effects Service Department.

Recommended Fluid

Ultratec Special Effects Fog Fluids: These fluids wre specifically designed to be used in our Ultra Handy
Fogger
These water-based fluids create a brilliant white fog that is dry and without leaving any residue.
www.ultratecfx.com
4