Table of Contents
Advertisement
Ultra Handy Fogger Setup
1. Open a 2 or 4 Liter Jug of Ultratec Special Effects Fog Fluid.
2. Remove the cap from the fluid tank of the Ultra Handy Fogger.
3. With the aid of a clean funnel, fill the Ultra Handy Fogger fluid tank with fluid.
4. Wipe up any spills that may have occurred and replace the cap on the fluid tank of
the Ultra Handy Fogger.
5. Tighten snugly.
Note:The cap has an integral seal to prevent leaks when in place, so over
tightening is not required.
Operating Procedure
Plug the unit into a suitable power source. The heat up time is approximately 8 minutes before fog can be
produced.
The Red Heater Status LED indicates heating when flashing slowly, within operating
temperature when flashing quickly, and fully heated when LED is "solid".
A three-flash pattern indicates an over temperature error.
1. When ready to produce fog, unplug the Ultra Handy Fogger from the
power outlet.
2. Disengage the Handy Clip from the pump plunger by flipping to the side.
3. Fog is produced by activating the pump plunger up and down.
It is the responsibility of the operator to ensure only "dry" fog is being produced and to stop producing fog when
it becomes "wet".
This is determined by waving your hand through the fog stream and observing any moisture on your palm.
Actual usage time depends on how much fog you are producing. The more fog you produce the shorter the
usage time becomes before reheat is required.
When the fog machine begins producing "wet" fog stop the fog cue and plug the Ultra Handy Fogger into the
power source to reheat.
When unplugged from a power source and fully heated, the Ultra Handy Fogger can hold heater block
temperature for about 40 minutes when no fog output is produced. But this time will drop significantly if fog is
produced.
3
www.ultratecfx.com
Fluid Cap
Pump Plunger
Handy Clip
Advertisement
Table of Contents
