Advertisement
Available languages
Available languages
6 Maintenance and cleaning
Service life of product extends and frequently
experienced problems will be reduced
if it is cleaned at regular intervals.
6.1 Cleaning the detergent drawer
Remove any powder residue buildup
in the drawer. To do this;
II
II
I
1. You can remove the detergent drawer
by pulling it towards yourself strongly.
C
INFORMATION
• If more than a normal amount of softener
and liquid detergent mixture starts to
remain in the softener compartment,
the siphon must be cleaned.
2. Wash the drawer and the siphon with
plenty of lukewarm water in a washbasin.
Wear protective gloves or use an
appropriate brush to avoid touching the
residues in the drawer when cleaning.
3. Replace the drawer into its housing
after cleaning. Check if the siphon
is in its original location.
6.2 Cleaning the loading
door and the drum
For products with drum cleaning
programme, please see Operating
the product - Programmes.
32 / EN
For products without drum cleaning programme,
follow the below steps to clean the drum:
Select Additional Water or Extra Rinse
auxiliary functions. Use Cottons programme
without pre-wash. Set the temperature to the
level recommended on the drum cleaning
agent which can be found in the detergent aisle
in supermarkets. Apply this procedure without
any laundry in the product. Before starting
the programme, put 1 pouch of special drum
cleaning agent (if the special agent could not
be supplied, put max. 1 tea-cup of (max. 100
g) of antilimescale powder) into the main wash
detergent compartment. If the antilimescale
is in tablet form, put only one tablet into the
main wash compartment no. "2". Dry the
inside of the bellow with a clean piece of cloth
after the programme has come to an end.
C
INFORMATION
• Repeat Drum Cleaning process
in every 2 months.
• Use an anti-limescale suitable
for the washing machines.
After every washing and drying make sure
that no foreign substance is left in the drum.
If the holes on the bellow shown in the figure
are blocked, open the holes using a toothpick.
C
INFORMATION
• Foreign metal substances will cause
rust stains in the drum. Clean the
stains on the drum surface by using
cleaning agents for stainless steel.
Never use steel wool or wire wool.
A
CAUTION!
• Never use sponge or scrub materials.
These will damage the painted,
chrome and plastic surfaces.
Washer-Dryer / User's Manual
Advertisement
