Operation And Stop; Electrical Circuit - veito CH1500 RE User Manual

Operation and Stop

The appliance is not to be used by children or persons with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction.
1- Start operation by pressing power setting or "AUTO" button.
2- Heater is turned on and operation is started with the sound of 'beep'.
3- Press "POWER" button to stop.
When you press the "AUTO" button, you can set the temperature by using the settings button.
Electronic temperature control automatically regulates power consumption based on your set
temperature and eliminates annoying hot and cold cycles.
When you press the "LEVEL" button, you can set the heat steps by using the settings buttons.
Heating capacity can be set to 4 different levels: 600W – 900W – 1200W – 1500W.
When you press the "TIMER" button, you can set the off time between 1 – 9 hours by using the
settings button.
When the timer is set, off timer lamp will light up and the heater will automatically shut down at the
end of the determined time.
To stop the off timer, set the timer as '0' or restart the heater.
When the heater is knocked over, it will automatically shut down.

Electrical Circuit

1. Triac
2. Carbon Flament
3. Power Cord
4. Yellow-Green (E)
5. White (N)
6. Black (L)
7. Off Timer
8. Tilt Sensor
9. Temperature Sensor
10. Mainboard
-7-