Troubleshooting - Bestway 53302 Owner's Manual

1
Fold all pieces of the water park toward the center.
Note: If bottom surface is still moist, allow it to air dry
prior to folding.
3 Slip the carrying bag over the rolled-up inflatable park. Flip the bag and the park over, close the
To extend the life of the water spraying hose assembly, store it in a adequately ventilated area. Do
Repair Patch Instructions
1
1. Defalte the item, clean the area and allow to dry thoroughly.
2. Cut a portion of the patch to the size needed and round the corners.(See Fig.1&2).
3. Apply the repair patch:
Option #1: Using the vinyl patch.
Remove the adhesive backing from the patch material, position the patch over the damaged area and smooth out any
bubbles.
Option #2: Using the fabric patch and the glue (not included).
Apply only the amount of glue(not included) needed to cover the repair site and press patch firmly over the puncture.
4. Allow to sit for 30 minutes before re-inflating.
Warning: Repair patched must be applied by an adult only. Keep out of children.

Troubleshooting

PROBLEM
Motor won't run
Motor runs but wheel makes a scraping noise
Motor is unable to run normally
bag, and store the park and the blower in a dry place.
not store them together with the park.
2
incorrect
2
Roll up the water park tightly
and compress the fabric to
expel all of the remaining air.
correct
or
CAUSE
1. Switch not turned on.
2. The circuit is opened or it is poor contact.
3. Electric capacity is damaged.
4. Choked up by hard objects.
1. Screws on the vaned wheel are loose.
2. Foreign objects in air-blower.
1. The voltage is unstable.
2. Motor is affected with damp.
3. Electric capacity is failure.
4. The impeller is loose.
6
Note: Do not place the water
spray tubing inside the water
park when rolling it up