Advertisement
Dynamo's 3-piece Shield set will help to keep the puck on the
table and discourage the placement of drinks on the table's side
rails. While it will create a safer environment, no shield has been
invented that will keep every puck on every playfield every time.
Exercise caution during play, keep hands and fingers clear of the
playfield, and follow the instructions from Dynamo Caution Label,
part # 850404030
Kit Contents:
Side Shields
Center Shield
Rubber Grommets
10-32 x 1½" Black Oxide Hex Bolts 4
Lock nuts
#10 Black Oxide Washers
Tool required
Phillips Screwdriver
1. Remove the bolts from the Side Top Rail, except for the bolt at the very
end of each Rail.
2. Insert Rubber Grommets into the holes from the top of each Side
Shield
3. Mount with the flange of the Shields to the outside.
4. Re-install the Top Rail bolts previously removed, start them by hand but
do not fully tighten until all bolts have been started.
5. Install (2) Rubber Grommets in each of the Side Shields, from the outside
6. Install the Center Shield by aligning it with the two holes in each Side
Shield. Hand thread the 4 bolts and 8 washers. Fully tighten once installed.
2
1
18
4
8
17
Advertisement
