Advertisement
Coin Door
Blue/Home
End
NOTE ALIGNMENT OF OVERHEAD MOUNTING TUBES
THIRD : Install Female and Male overhead mounting
tubes on opposite sides of the table as used on the
first two, use the diagram above as your guide.
Now, all four mounting tubes should be installed on
the table, with the wire harness accessible.
Install the third mounting bolt in
each of the four legs to secure the
overhead mounting tubes to the
legs. As with the first eight leg
bolts, use the bushings and take
care to prevent the bushing from
damaging the side decal.
The overhead bracket will have
THREE bolts installed to secure it.
Align the bracket so the corner
WITHOUT the bolt corresponds to
the overhead mounting tube
containing the Overhead Wire
Harness (note diagram above).
Tap the bracket with the rubber
mallet to install it atop the Overhead
Mounting Tubes.
Continue to watch that the wire harnesses
are not pinched, crimped or otherwise
restrained during the assembly process.
14
No bolt
Service Door
Red/Visitor
End
Advertisement
