Installation And Connection - Telestar Imperial CAR 1 Operating Manual, Installation Instructions

6. INSTALLATION AND CONNECTION

- For safety reasons, please allow the installation and connection of the device to be performed by trained specialist personnel.
- If necessary, search for a specialist workshop to have the connection of the radio performed.
- The device may only be operated with a 12 volt DC operating voltage.
- Disconnect the negative battery connector (ground) before wiring the radio to the car battery.
- To avoid a short circuit, make sure that the connection cables of the vehicle's wiring harness do not touch.
- Note that the connection of the ISO plug must be connected to the radio's ignition lock to ensure the radio is switched off while the ignition
is turned off.
- When drilling holes, make sure that no vehicle parts are damaged.
- The cross-section of plus and minus cables should not fall below 1.5 mm2.
- Depending on the vehicle type, this description may differ. We accept no liability for damage due to installation or connection errors.
- Please note that when installing an audio amplifier, the housing ground must first be connected before the plugs for the LINE Out sockets
can be connected.
NOTE:
This radio is equipped with a standard ISO 10487 connector that is compatible with most vehicle types.
If your vehicle has a different radio connection that does not comply with this ISO, please contact your car service partner or a specialised dealer for
car radio accessories.
61
E
IMPERIAL CAR 1 /CAR 2