19
|
Configuration
19.2.2 To access the field setting components
19.2.3 Field setting components
Installer and user reference guide
108
PC configurator
You can also make field settings through a personal computer interface (for this,
option EKPCCAB* is required). The installer can prepare the configuration (off-site)
on PC and afterwards upload the configuration to the system.
See also:
"To connect the PC configurator to the compressor
Mode 1 and 2
Mode
Mode 1
(monitoring settings)
Mode 2
(field settings)
See
"To open the compressor
The components to make field settings differ depending on the model.
Model
5 HP
▪
▪
▪
▪
8 HP
▪
▪
▪
Mode 1 can be used to monitor the current situation of
the compressor unit. Some field setting contents can be
monitored as well.
Mode 2 is used to change the field settings of the
system. Consulting the current field setting value and
changing the current field setting value is possible.
In general, normal operation can be resumed without
special intervention after changing field settings.
Some field settings are used for special operation (e.g., 1
time operation, recovery/vacuuming setting, manual
adding refrigerant setting, etc.). In such a case, it is
required to abort the special operation before normal
operation can restart. It will be indicated in below
explanations.
4
unit" [
66].
Field setting components
Push buttons (BS1~BS5)
7‑LEDs display (H1P~H7P)
H8P: LED for indication during initialisation
DIP switches (DS1)
Push buttons (BS1~BS3)
7‑segments display (
DIP switches (DS1 and DS2)
4
unit" [
122].
Description
)
RKXYQ5T8+8T7Y1B + RDXYQ5T8+8T7V1B
VRV IV heat pump for indoor installation
4P499898-1A – 2020.10