REED CPDWW Instructions

Note: Only for waterworks use. For adding power to
valve exercising or for tapping/drilling machines.
Cordless Power Drive
for Waterworks
WORK AREA
1. Keep your work area clean and well lit. Cluttered benches and
dark areas invite accidents.
2. Do not operate power tools in explosive atmospheres, such as
in the presence of flammable liquids, gases, or dust. Power
tools create sparks which may ignite the dust or fumes.
3. Keep bystanders, children, and visitors away while operating
a power tool. Distractions can cause you to lose control.
PERSONAL SAFETY
1. Stay alert, watch what you are doing and use common sense
when operating a power tool. Do not use tool while tired or
under the influence of drugs, alcohol, or medication. A
moment of inattention while operating power tools may result
in serious personal injury.
2. Dress properly. Do not wear loose clothing or jewelry. Contain
long hair. Keep your hair, clothing and gloves away from mov-
ing parts. Loose clothes, jewelry, or long hair can be caught in
moving parts.
PHONE: 800-666-3691 or 814-452-3691 Fax: 800-456-1697 or +1-814-455-1697
For Valve Exercising
- requires VOKUCLUTCH
REED MANUFACTURING
1425 West Eighth St.
www.reedmfgco.com
For Tapping/Drilling
- requires TMPDA
3. Avoid accidental starting. Be sure switch is OFF before
attaching battery. Carrying tools with a finger on the switch or
attaching batteries to tools that have the switch ON invites
accidents.
4. Remove adjusting keys or wrenches before turning on the tool.
A wrench or a key that is left attached to a rotating part of the
tool may result in personal injury.
5. Do not overreach. Keep proper footing and balance at all
times. Proper footing and balance enables better control of the
tool in unexpected situations.
6. Use safety equipment. Always wear eye protection. Dust
mask, non-skid safety shoes, hard hat, or hearing
protection must be used for appropriate conditions.
SAVE THESE
INSTRUCTIONS!
Erie, PA 16502 USA
CPDWW
#05258
1
1020-55259